How to Use This Script

• Initial Setup
  • Set the control bindings in the script to match your in-game controller settings.
• Menu Navigation
  • Open Menu: Menu Button + LT
  • Navigate:
    • D-Pad Left/Right: Switch modes
    • D-Pad Up/Down: Adjust values
  • Toggle Features: D-Pad Up/Down
  • Edit Values: Press A/X when “EDIT” is shown
  • Exit Menu: Press B
  • Toggle All Features: VIEW + LT
• Adjusting Recoil In-Game
  • Enter Menu (Menu + LT)
  • Go to Operators → Choose side → Select operator
  • Choose primary or secondary weapon
  • Press A/X to enter adjustment mode
  • Use D-Pad Left/Right to switch between:
    • VERTICAL: Up/Down adjusts vertical recoil
    • HORIZONTAL: Up/Down adjusts horizontal recoil
    • DEADZONE: Up/Down adjusts stick sensitivity
• Weapon Switching
  • If your primary/secondary weapons get mixed up:
  • Pause the game
  • Press your bound weapon switch button
  • This will reset the weapon assignment
• Troubleshooting
  • If the script stops responding:
  • Toggle mod off/on (Menu + LT)
  • Check your controller connection
  • Restart the game
  • Reopen the menu if unresponsive

Permanent Recoil Setup

• Recoil tuning requires 10–20 minutes per operator
• Fine-tuning leads to better long-term recoil control
• To save settings permanently, locate these arrays in the INIT section:
  • Attackers
    • attackerVerticalRecoil[]
    • attackerHorizontalRecoil[]
    • attackerVerticalRecoilSecondary[]
    • attackerHorizontalRecoilSecondary[]
  • Defenders
    • defenderVerticalRecoil[]
    • defenderHorizontalRecoil[]
    • defenderVerticalRecoilSecondary[]
    • defenderHorizontalRecoilSecondary[]
• Example for Ash (index [2] in arrays):
• attackerVerticalRecoil[2] = 33;
• attackerHorizontalRecoil[2] = -1;
• attackerVerticalRecoilSecondary[2] = 19;
• attackerHorizontalRecoilSecondary[2] = 1;
• Value guidelines:
  • Vertical: 0–100 (positive pulls down)
  • Horizontal: -100 to 100
    • Negative: compensates right sway
    • Positive: compensates left sway

Finding Proper Recoil Values

• Go to the Shooting Range in-game
• Fire a full magazine at a wall
  • Observe vertical and horizontal movement
• Start with the default values in the script
• Adjust recoil in small increments (5–10 points)
• Test fire after every adjustment
• Suggested Tuning Order:
  • Set vertical until recoil is neutralized
  • Adjust horizontal to eliminate sideways drift
  • Only adjust deadzone if the default (20) doesn’t work
• Note: Recoil control also depends on your in-game sensitivity and weapon attachments.